This module is used for controlling 0-10V devices. The module can be controlled either through a NEXUS-NERO Communications Gateway or through a wall switch.

The NERO-10VDIM module measures the power consumption of lights and supports connection of a NERO-TEMP digital temperature sensor.

It is designed to act as repeater to improve range and stability of the Z-Wave Network.

 

1. INSTALLATION

​

• Disconnect the power supply before installation.

• Connect the module according to the electrical

  diagram.

• Position the antenna as far from metal elements

  as possible.

• Do not shorten the antenna.

​

1.1 Supported Switches

The module supports momentary switches (push button), toggle switches, and potentiometer. The module is factory set to operate with momentary switches.

​

1.2 Overcurrent Protection Fuse

Electrical installation must be protected by over current protection fuse ESKA 522.504 50mA 250V or equivalent, as illustrated in the wiring diagram.

 

Danger of electrocution!

• Module installation requires a great degree of skill and may be performed only by a qualified and licensed electrician.

• Even when the module is turned off, voltage may be present on its terminals. Any works on configuration changes related to connection mode or load must always be performed with a disconnected power supply.

 

Note: Do not connect the module to loads exceeding recommended values. Connect the module only in accordance to the below diagram. Improper connections may be dangerous. 

 

2. WIRING DIAGRAMS 

2.1 Electrical diagram

 

+      12-24 VDC
-       12-24 GND

O+   Output 0-10 VDC

O-    Output 0-10 GND

I1-    Input GND

I1     Input for switch, potentiometer, 0-10 VDC

TS    Connector for NERO-TEMP

​

​

​

​